SJSC Flow Control Valve | Flow Control Regulator | Stainless Steel Push in Fittings

SJSC stainless steel push in fitting flow control valve (flow control regulator) has a male thread on one end and a tubing connection on the other end at 90-degree angle, provides accurate flow regulation for precise speed control of pneumatic cylinders as well as gas flow in environments with high mechanical or chemical constraints. Stainless steel push in fitting flow control valve (flow control regulator) is made of 316 stainless steel for higher strength and greater corrosion resistance than 304 stainless steel, the FKM sealing material is chemical-resistant. These stainless steel flow control valves (flow control regulators) are designed to be used in the food, dairy, pharmaceutical and chemical industries, as well as extreme hot and cold conditions. In this category you can find stainless steel push-in fittings with threads in following sizes: R, PT, BSPT 1/8 to R, PT, BSPT 1/2, and 10-24 UNC, 10-32 UNF, 10-32 UNF,1/8 NPT to 1/2 NPT for hoses with diameter from 4 mm to 16 mm and 1/8" to 1/2". Control-out and control-in flow control valves (flow control regulators) are available.

Control-out flow control valve controls the flow rate of air entering from the thread side can be controlled, whereas air entering from the tube side comes out from the thread side at the same (not controlled) flow rate.

Control-in flow control valve controls the flow rate of air entering from the tube side can be controlled, whereas air entering from the thread side comes out from the tube side at the same (not controlled) flow rate.

Part #: SJSC Flow Control Valve / Flow Control Regulator
Fluid Admitted: Air, Vacuum, Water (no freezing), Steam
Thread Size: From BSPT 1/8 to BSPT 1/2; 10-24 UNC to 1/2 NPT
Body Material: 316 Stainless Steel
Material: 316 Stainless Steel
Sealing: FKM (Viton)
Working Pressure: 0—2.0 MPa | 0—290 psi
Proof Pressure: 3.0 Mpa | 435psi
Negative Pressure: -100 Kpa | -29.5 In Hg
Working Temperature: -20～150°C | -4～302°F